14 ideas for side yards
A California couple turned a narrow 15- by 30-foot corridor outside their home into a cozy, colorful alfresco living room with these five features we love:
- Trellis for shade. A coated aluminum trellis overhead provides some shade, but its opening lets through enough daylight to bathe a privacy wall and fountain.
- Floral backdrop. Plants that tolerate drought and heat―including gaura, lavender, and salvia―draw the eye toward the back fence.
- Longer patio. The new patio is roomier than the deck it replaced. Rosy cocoa tiles enhance the expansive feel, as do the pavers.
- Curving seat wall. Topped with Arizona flagstone, this distinctive feature curves from the patio's end to the firepit.
- Fountain. A freestanding, stucco-faced wall, built 3 feet in from the property line and painted a rich persimmon hue, helps mask a neighbor's home. Water passes through a slit near the wall's top and falls through a bed of cobbles into an underground basin, then recirculates.
Dotting your space with containers is an easy way to add cheer. Take the stylish and easy route by using self-watering containers, which you can make yourself by following these simple steps:
- Start with a thin-walled, nonporous pot (at least 12 inches wide and 16 inches high) that has no drainage hole but will be easy to drill into—like the plastic ones shown here (Skörd planter, from $30; ikea.com). Drill a 1/4-inch- wide hole into its side, about 4 inches up from the bottom.
- Take a smaller plastic pot— roughly 6 by 6 inches—and drill 1/4-inch-wide holes, a few inches apart, into the sides and bottom. Fill with potting soil, then center in the bottom of the large container. (If your large pot is wide, like the one shown above right, use two small pots.)
- Cut a disc of sturdy plastic (we used the lid of an old storage bin) to fit securely in- side the large pot when sitting on top of the soil- filled one. Drill 1/4-inch holes, an inch apart, in the disc. Cut a 1-inch-wide hole near the disc’s edge, then place the disc on the pot, inside the large container.
- Cut a length of 1-inch PVC pipe that’s slightly longer than the height of the large container. Cut the bottom of the pipe at an angle (so it won’t clog), and insert the pipe through the 1-inch hole in the disc. Push pipe as far into the big pot as it will go.
- Set your plant on the plastic disc (next to the pipe). Fill in the space around it with potting soil, mixed with some controlled-release organic fertilizer, to 1 to 2 inches below the pot’s rim. (Don’t worry if some soil falls through to the reservoir below.)
- Cover the top of the soil with plastic sheeting, cutting an X in it to let the plant through and tucking it down into the sides of the pot. Hide the plastic with a layer of rock or bark. Pour water down the pipe until it flows from the drainage hole. Refill as needed, likely once or twice a week.