A garden tower with the crisp geometry of an obelisk adds a stunning focal point and a vertical dimension to your garden. Once vines climb onto the obelisk, the contrast between natural and constructed elements will enhance the appeal.
This obelisk is made from pressure-treated lumber, left to weather naturally.
Building the obelisk isn’t that difficult if you have good tools and basic carpentry skills. There are some tricky angled cuts, though, that you’ll need to make to get the legs to splay correctly.
The good thing is that even if you are off a little bit, the tower will still work. Because the legs are long, you can flex them slightly to get everything to line up.
Start with a post top with a pointy finial. Then, rip-cut the lath pieces. The gallery photos show attaching with screws, but you can also use power-driven finish nails and staples; don’t attempt to hand-nail.
You can apply exterior wood glue or polyurethane glue to the joints for added strength.
Next: Materials listMaterials list
- One 4 x 4 fence post with finial, cut about 14" long
- Four 8' 2 x 2s for 93½" legs
- One 8' 2 x 4 for four 22" spreaders
- Four 4' pieces of ¼" x 1½" lath, perhaps rip-cut from a 2 x 4, for: four 17½" lower crosspieces, four 14" middle crosspieces, and four 10½" upper crosspieces
- Four 7' pieces of ¼" x 1" lath, perhaps rip-cut from 5⁄4 decking, for four long verticals
- Eight 5' pieces of ¼" x 1" lath for eight shorter verticals
- 1¼" and 2" decking or stainless-steel screws
Pro tip: The importance of pilot holes
Especially when you are working with ¼-inch lath, which splits easily, countersink your pilot holes. Pilot holes seem like a hassle, but are well worth the amount of time they require. Use a drill bit that is slightly narrower than the screw or nail. The pilot holes countersink the screws, so the heads sit perfectly flush with the board for a neater appearance.