Create a leafy eye-catcher for a garden wall

Get our diagrams and step-by-step photos for this great wall trellis

Wall Panels Complete

Wall-attached trellis panel

More arbors and trellises

This tall, wall-attached trellis panel is elegantly simple. You may want to build several and space them one panel’s width apart,.

For a trellis like this, the exact dimensions of the pieces can make a big difference in the overall appearance. We show lattice that is ¾ inch thick and 11⁄8 inches wide. You could use standard 1 by 2s, which are ¾ inch by 1½ inches, but the result would be surprisingly clunky-looking. Rip-cutting the slats will take only a half hour or so.

Get our step-by-step instructions

Getting ready

There are no half-lap joints, so this project can be built quickly. Start by rip-cutting the lattice slats and frame pieces. Because the trellis will be attached to the house, the frame need not be very strong and can be assembled with a single screw at each joint.

Since both vertical and horizontal pieces run around the perimeter of the lattice, the frame can be simply attached.

The grid shown here is 68 by 22 inches, but you could widen or lengthen it. If you widen it by more than 8 inches, add another vertical lattice piece. Here we use cedar, but you could use treated lumber, which can be stained or painted.

Next: diagram and materials list

 

Materials list

Materials tip

Cedar is often knotty, so choose boards with the fewest and smallest knots that you can find. You may need to throw out some pieces with knots (they will break easily), and you can use some shorter pieces for the horizontals. Also choose relatively clear lumber for the frame.

Printed from:
http://www.sunset.com/garden/build-wall-attached-trellis-panel-00400000039516/